Skip to main content

Chemtex manufactures Coolant Corrosion Inhibitors to protect diesel engine cooling systems.


Automobile industries are manufacturing diesel engines nowadays mostly.These engines are known for their better fuel efficiency & cost effectiveness.


These engines from time to time accumulate huge sludge & mineral deposits.Infact the diesel engine can overheat naturally & also cause shutdown of the system.


So to protect the cast iron diesel engine coolant corrosion inhibitor is being used.This chemical is known for some major benefits:-


·        It is combined with chemical additives that protect against sludge and mineral scale deposits.

·        It is effective against liner pitting and cavitation erosion.

·        It prevents over heating of engine and thus reducing chances of shut down.  

·        Not harmful to radiator or heater connecting hoses, diesel liner seals and ‘O’rings

This product protects cooling systems against corrosion, liner pitting, cavitation-erosion, mineral scale deposits and electrolysis.


Chemtex manufactures coolant corrosion inhibitor which is equivalent or even better than Nalcool 2000, Inhibitor 231,Inhibitor 234, Inhibitor 244, etc

Dosage:
Diesel Engine Corrosion Inhibitor is directly added to the water or coolant mixture in the recommended dosage depending upon the engine capacity and load. A routine top-up is required to maintain the concentration of product as adviced.


Application:-
This product is applicable in all types of radiators,engine jackets & engine coolants.
Contact Us

Chemtex Speciality Limited 
Regd. Office:33 Brabourne Road, Kolkata 700 001,West Bengal, India 
Phone : +(91)-(33)-7111-1111 / 7111-1112 Fax : +(91)-(33)-7111-1117
Mobile : +(91)-896-111-1111



Labels

Labels:

Popular posts from this blog

H2S – A Silent Ultimatum to Oilfields

H 2 S Scavenger Chemical – Introduction The world has witnessed a substantial increase in E&P of crude oil to meet the need for globalization, leading to drilling of ‘deemed undesirable’ sites, owing to the presence of higher concentration of acidic gases like hydrogen sulphide, carbon dioxide, etc. These hazardous gases require proper measures before disposal or scavenging. Of these, Hydrogen sulphide/ H 2 S is the most threatening one, especially in confined or ill ventilated places. The characteristic rotten egg smell makes H 2 S recognition easy even at lower concentrations. Hydrogen Sulphide is toxic, acidic and extremely corrosive at higher concentrations. Heavier than air, it is found more near base level of the working sites. Then comes its inflammability, which may cause explosive reaction with air molecules. With peroxides, ammonia and other oxidizing chemicals, H 2 S often goes through combustible reactions, ...
Read more

Enhance IAQ of Closed Spaces with Air Fumigation: ALSTASAN SILVOX 150 FUME

Chemists around the world have shown considerable interest in various aspects and working of Hydrogen Peroxide as a disinfectant at different concentration. Over the past few years, it has been observed by them that a mere 0.5% of Hydrogen Peroxide shows excellent antiviral property within 60 seconds of application, reason being a strong oxidizing agent which helps in eliminating harmful microorganisms wherever used. It oxidizes the cell molecules, rupturing its whole structure and deactivating its ability to replicate. With silver, it has relatively wider range of biocidal (anti-bacterial and anti-fungal) pursuits than other disinfecting chemicals. Since Hydrogen Peroxide is a strong oxidizing agent and silver shows excellent anti-microbial property, their chemical combination brings a lot to the table as a rapid yet effective disinfecting agent with limited or rather no toxicity. Taking the above ideas into consideration, We at Chemtex Speciality Limited have come up with a brand n...
Read more